hello,

I have six Wansview W3 I.P. cameras connected through WiFi. When I open Surveillance Station and Camera Overview some of my cameras keep dropping connection status from Connected to Idle. The bit rate for the cameras goes from 2.4Mbps to as little as 725KBps.
I can not understand how I have such low connections when if I map my network with my router app the lowest link rate is 56 Mbs with a signal strength of 62%.
I have a TS-453A wired by ethernet to a Netgear R7800 (two feet away)that is connected to my Virgin media hub that is in modem mode.
All cameras have static I.P.s
I have one Netgear WiFi extender that is set up correctly

Please help.
Thanks!

I didn't find the right solution from the Internet.

References:
https://forum.qnap.com/viewtopic.php?f=187&t=137350


Branding Motion Graphics Example